Spa FilterFix 1L

FilterFix cleans filters in outdoor hot tubs. A spa filter efficiently collects small particles and impurities, including dead skin cells. Particles can cause deposits that block the filter. That is why you need to clean the filter every 2-3 weeks.

Instructions for use:

Rinse the filter thoroughly under running water. Remove all dirt and deposits from the filter slats. Then place the filter in a clean plastic bucket. Fill with clean water until the filter is completely immersed.

Dosage: For 10 litres of water add 100 ml of FilterFix. Leave the filter to soak in the solution for at least 12 hours. Rinse the filter thoroughly under running water. The filter is now ready for use again.

Use the lid as a measuring cup:
The lid of this product acts as a measuring cup, so you can easily and accurately measure the correct amount.
Make sure chemicals do not get damp during storage. Store in original packaging, locked and out of the reach of children in a dry frost-free place away from direct sunlight.

DANGER

Contains: Sulphuric acid 150 g/kg. May be corrosive to metals. May be corrosive to metals (H290). Causes severe skin burns and eye damage (H314). If medical advice is needed, have product container or label at hand (P101). Do not breathe vapour/mist (P260). Wear eye protection/protective gloves (P280).

IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water (P303+P361+P353).

IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing (P305+P351+P338).

Store locked up (P405). Dispose of contents/ container in accordance with local regulation (P501).

1 L. 648/2004: <5% non-ionic surfactants.